Pneumatic Forklifts

Pneumatic Forklifts Training Brampton - Pneumatic lifts are known as pallet trucks or pump trucks and are broadly used in warehouses and transport facilities to transfer resources on pallets. Pneumatic forklifts include a set of metal forks installed on a wheeled counterbalance that contains a pump. The pump is used to lift and lower the forks.

Visually check the pallet lift before loading. Make sure the wheels are free of any impending obstacles. Also, make sure the handle moves easily and turns properly. Inspect the pallet before moving it to determine if it is stacked in a way that minimizes the chance of anything falling off during lifting. Discharge any air in the pump and lower the blades to the floor by squeezing the lever installed on the inside of the steel loop on the end of the lever. Run the blades into the slots in the pallet and make sure the forks are centered so that the pallets' mass is evenly distributed.

Pump the pneumatic jack handle up and down to lift the forks from the floor. Stop pumping once the pallet is completely off the ground as there is no need to lift it any higher or risk losing balance while turning. In order to shift the pallet, tow the handle behind you; do not push it. There will be a large amount of momentum existing. Avoid quick or sharp turns and you should not stop too suddenly. Gently bring the pallet to a halt where you would like to park it. Squeeze the handle inside the grip end to restore the forks to the floor. Withdraw the forks and restore the pallet jack to a proper parking area or continue onto the next undertaking.

Click to Download the pdf